Thermal buckling and post-buckling behaviour of continuous welded rail track

Because thermal expansions are constrained within continuous welded rail track, the track can buckle, and does so mainly in the horizontal plane. In this paper, a parametric finite element model of railway track is presented, and its sensitivity to the variations of the main parameters that characterise the scenario has been investigated and discussed. Comparison with existing literature shows good agreement. It is found that curved tracks suffer from thermal buckling more than tangent tracks do. To simulate a track misalignment defect, a new methodology has been utilised that does not introduce, as is usual, geometrical discontinuities near the same defect, because it takes into account – in a natural way – the bending stiffness of the whole railway track in the horizontal plane. To contribute to a better understanding of the safe utilisation of raw experimental data obtained from in situ tests, a deep analysis of the effects on the thermal track buckling response produced by each parameter characterising the sleeper–ballast lateral resistance curve is presented and discussed. It is found that for current ballasted railway tracks, the minimum buckling temperature depends only on the limit lateral resistance, whereas a high value of the initial stiffness can lead to overestimation of the maximum buckling temperature, also taking into account the ‘natural’ decrease in the maximum buckling temperature due to an increase in the railway-traffic-induced defect amplitude.