A series of hard chine planing hull forms was developed at Department of Naval Architecture, University of Naples. Three warped and one monohedral hulls were designed and four 6 ft long models were built. The models have the same transversal section at 0.25L from the stern with 16.7 degrees deadrise angle. Warped models had deadrise angle linearly varying along the hull length. Aim of the experimental program is the evaluation of the effect of deadrise angle variation along the hull length on hydrodynamic resistance and on seakeeping although this work presents calm water performances only. The models have clear polycarbonate bottom to allow flow visualization and accurate wetted surface assessment. Resistance tests were performed for speed coefficient CV ranging from 0.56 to 3.92 and for two load coefficient values: CD = 0.428 and 0.392. Reported results are wetted lengths of pressure area and whisker spray area, projected angles of stagnation line, wetted surface and whisker spray area, residual resistance coefficient, sinkage, presented in standard non-dimensional form, and running trim.

Resistance assessment of warped hullform / Begovic, Ermina; Bertorello, CARLO FRANCESCO MARIO. - In: OCEAN ENGINEERING. - ISSN 0029-8018. - 56:(2012), pp. 28-42. [10.1016/j.oceaneng.2012.08.004]

Resistance assessment of warped hullform

BEGOVIC, ERMINA;BERTORELLO, CARLO FRANCESCO MARIO
2012

Abstract

A series of hard chine planing hull forms was developed at Department of Naval Architecture, University of Naples. Three warped and one monohedral hulls were designed and four 6 ft long models were built. The models have the same transversal section at 0.25L from the stern with 16.7 degrees deadrise angle. Warped models had deadrise angle linearly varying along the hull length. Aim of the experimental program is the evaluation of the effect of deadrise angle variation along the hull length on hydrodynamic resistance and on seakeeping although this work presents calm water performances only. The models have clear polycarbonate bottom to allow flow visualization and accurate wetted surface assessment. Resistance tests were performed for speed coefficient CV ranging from 0.56 to 3.92 and for two load coefficient values: CD = 0.428 and 0.392. Reported results are wetted lengths of pressure area and whisker spray area, projected angles of stagnation line, wetted surface and whisker spray area, residual resistance coefficient, sinkage, presented in standard non-dimensional form, and running trim.
2012
Resistance assessment of warped hullform / Begovic, Ermina; Bertorello, CARLO FRANCESCO MARIO. - In: OCEAN ENGINEERING. - ISSN 0029-8018. - 56:(2012), pp. 28-42. [10.1016/j.oceaneng.2012.08.004]
File in questo prodotto:
Non ci sono file associati a questo prodotto.

I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.

Utilizza questo identificativo per citare o creare un link a questo documento: https://hdl.handle.net/11588/510054
Citazioni
  • ???jsp.display-item.citation.pmc??? ND
  • Scopus 67
  • ???jsp.display-item.citation.isi??? 53
social impact