The study of an innovative “active” cooling system of a wing leading edge of a hypersonic re-entry vehicle making use of water is addressed. In particular, a steady model is developed to study the critical discharge of the cooling water into a very low pressure ambient simulating the outlet conditions for both the re-entry and wind tunnel environments. Due to the strongly subcooled operating conditions, the model predicts no-flashing within the duct connecting the outlet (hot) manifold to the vacuum ambient. The mass flow rate needed to remove the aerodynamic heat load acting on the external surface is calculated by an iterative procedure. At each iteration, for a fixed value of the mass flow rate, the pressure within the outlet manifold is calculated and the exit section critical pressure is determined as well. Subsequently, a detailed thermo-fluid-dynamic analysis is conducted to evaluate the head losses within the pipes and the peak wet wall temperature. The iteration stops when the mass flow rate guarantees no-boiling conditions throughout the system. The findings arising from the steady model are confirmed by unsteady numerical simulations of the system start-up.
Critical discharge in actively cooled wing leading edge of a re-entry vehicle / Mongibello, L.; DE LUCA, Luigi. - In: JOURNAL OF THERMOPHYSICS AND HEAT TRANSFER. - ISSN 0887-8722. - ELETTRONICO. - 22:4(2008), pp. 677-684. [10.2514/1.33824]
Critical discharge in actively cooled wing leading edge of a re-entry vehicle
DE LUCA, LUIGI;
2008
Abstract
The study of an innovative “active” cooling system of a wing leading edge of a hypersonic re-entry vehicle making use of water is addressed. In particular, a steady model is developed to study the critical discharge of the cooling water into a very low pressure ambient simulating the outlet conditions for both the re-entry and wind tunnel environments. Due to the strongly subcooled operating conditions, the model predicts no-flashing within the duct connecting the outlet (hot) manifold to the vacuum ambient. The mass flow rate needed to remove the aerodynamic heat load acting on the external surface is calculated by an iterative procedure. At each iteration, for a fixed value of the mass flow rate, the pressure within the outlet manifold is calculated and the exit section critical pressure is determined as well. Subsequently, a detailed thermo-fluid-dynamic analysis is conducted to evaluate the head losses within the pipes and the peak wet wall temperature. The iteration stops when the mass flow rate guarantees no-boiling conditions throughout the system. The findings arising from the steady model are confirmed by unsteady numerical simulations of the system start-up.File | Dimensione | Formato | |
---|---|---|---|
deLuca_DIAS_JThermophysics_2.pdf
non disponibili
Tipologia:
Documento in Post-print
Licenza:
Accesso privato/ristretto
Dimensione
1.21 MB
Formato
Adobe PDF
|
1.21 MB | Adobe PDF | Visualizza/Apri Richiedi una copia |
deLuca_DIAS_JThermophysics_1.pdf
non disponibili
Tipologia:
Documento in Post-print
Licenza:
Accesso privato/ristretto
Dimensione
1.2 MB
Formato
Adobe PDF
|
1.2 MB | Adobe PDF | Visualizza/Apri Richiedi una copia |
I documenti in IRIS sono protetti da copyright e tutti i diritti sono riservati, salvo diversa indicazione.