Stress distributions in adhesively cemented ceramic and resin-composite Class II inlay restorations: a 3D-FEA study.

Summary Objectives: The purpose of this study was to investigate the effect of differences in the resin-cement elastic modulus on stress-transmission to ceramic or resin-based composite inlay-restored Class II MOD cavities during vertical occlusal loading. Methods: Three finite-element (FE) models of Class II MOD cavity restorations in an upper premolar were produced. Model A represented a glass–ceramic inlay in combination with an adhesive and a high Young’s modulus resin-cement. Model B represented the same glass–ceramic inlay in combination with the same adhesive and a low Young’s modulus resin-cement. Model C represented a heat-cured resincomposite inlay in combination with the same adhesive and the same low Young’s modulus resin cement. Occlusal vertical loading of 400 N was simulated on the FE models of the restored teeth. Ansyse FE software was used to compute the local von Mises stresses for each of the models and to compare the observed maximum intensities and distributions. Experimental validation of the FE models was conducted. Results: Complex biomechanical behavior of the restored teeth became apparent, arising from the effects of the axial and lateral components of the constant occlusal vertical loading. In the ceramic-inlay models, the greatest von Mises stress was observed on the lateral walls, vestibular and lingual, of the cavity. Indirect resin-composite inlays performed better in terms of stress dissipation. Glass–ceramic inlays transferred stresses to the dental walls and, depending on its rigidity, to the resin-cement and the adhesive layers. For high cement layer modulus values, the ceramic restorations were not able to redistribute the stresses properly into the cavity. However, stress-redistribution did occur with the resincomposite inlays.