Jet-pacs project: Dynamic experimental tests and numerical results obtained for a steel frame equipped with hysteretic damped chevron braces

The experimental and numerical results obtained by Research Units of the University of Basilicata and University of Calabria for a steel frame, bare or equipped with metallic yielding hysteretic dampers (HYDs), are compared. The shaking table tests were performed at the Structural Laboratory of the University of Basilicata within a wide research program, named JETPACS ("Joint Experimental Testing on Passive and semiActive Control Systems"), which involved many Research Units working for the Research Line 7 of the ReLUIS (Italian Network of University Laboratories of Earthquake Engineering) 2005-2008 project. The project was entirely founded by the Italian Department of Civil Protection. The test structure is a 1/1.5 scaled two-story, single-bay, three-dimensional steel frame. Four HYDs, two for each story, are inserted at the top of chevron braces installed within the bays of two parallel plane frames along the test direction. The HYDs, constituted of a low-carbon U-shaped steel plate, were designed with the performance objective of limiting the inter-story drifts so that the frame yielding is prevented. Two design solutions are considered, assuming the same stiffness of the chevron braces with HYDs, but different values of both ductility demand and yield strength of the HYDs. Seven recorded accelerograms matching on average the response spectrum of Eurocode 8 for a high-risk seismic region and a medium subsoil class are considered as seismic input. The experimental results are compared with the numerical ones obtained considering an elastic-linear law for the chevron braces (in tension and compression), providing that the buckling be prevented, and the Bouc-Wen model to simulate the response of HYDs.